How The Pros Do It

Product Description Aurora VS 721 BOTTOM COATis a perfectly clear bottom wax that utilizes the super slippery characteristics of VS721 fouling release polymer for its properties. It is easily applied with a damp sponge or cloth and buffed to a high shine.

For best results the boat bottom must be clean and dry. De-wax with Aurora Boat Clean Plus and deep clean with Aurora Boat Scrub. Remove algae, barnacles and mussels with Aurora Algae Strip and waterline stains with Aurora Waterline Stain Remover.

(NOTE: Aurora VS721 Bottom Coat can NOT be applied over existing antifouling paint.)

The finish is clear, shinny and very slippery. Your boat bottom will look like new. One bottle will protect a 25 foot boat with one coat.

 Features & Benefits

• Protects against algae, zebra mussels, barnacles.
• Seals fiberglass bottoms to prevent osmosis blisters.
• Reduces hull friction for higher speed and reduced fuel consumption.
• Can be applied to power, sail and trailered boats as well as PWC's, jet boats, fishing boats and pontoons.
• Non conductive. Will not cause galvanic action.
• Apply to fiberglass, aluminum and hard painted surfaces.
• Apply to all under water surfaces (drives, struts, shafts, trim tabs, through hulls, etc.) except props. Aurora VS 721 Bottom Coat is so slippery it will cause props to slip.
• Ideal for trailered boats. Hard surface won't rub off on rollers or bunks.
• Environment friendly, No biocides or copper. Won't poison fish or marine life.
• Used by racers. Sailboats move in light airs, power boats gain top end speed and reduce kiting.
• Dirt and salt are easily removed with a garden hose.
• Normal running of the boat will keep hull clean of algae and slime.

How the Pros Do It - Tips & Tricks

 1.       Apply with a large damp sponge. Application is faster and easier.

2.       Use pressure to force wax into microscopic pores and crevices. This seals the pores against osmosis blistering.

3.       For large surfaces, apply with a low speed orbital buffer so that more pressure can be applied.

4.       Apply 2 coats, minimum 24 hr. drying time between coats. Wait minimum 48 hours from the last coat before launching.

5.       Buff residue off with old terry towel. A brilliant, better than new, shine will result.

6.       If slime or light algae appears (usually on the transom or waterline) wipe off with sponge or deck brush as required.

 What Others Say

 "We picked up a full mile per hour!  In race conditions, the boat had a more stable feel; I couldn't believe how easily the boat was to clean up after the race. We also got a lot of compliments on how good the boat looked. The shine was impressive. Congratulations on your technical achievements. I believe that your High Performance VS721 BOTTOM COAT can improve the speed, performance and appearance of all race and pleasure boats."

Chip Fendt, World Champion Offshore Driver

V.P. Dealer Development, Hustler Boats

"I have no algae growth or zebra mussels an my boat. I boast your product to all my friends and neighbors at the Marina."

M. Cook, Port Colborne

"I was amazed with the results I got from using your VS721 BOTTOM COATon my boat. It really does prevent osmosis. I am now using it on my other boats."

Barry Brackley, Scarborough

"I used your ALGAE STRIP, BOAT SCRUB AND VS721 BOTTOM COAT for the first time this year. You people are the first company I've dealt with that make a product that does what you say it'll do."

Dave, Anchorage Marine

"Your products are the best I've ever used. Where is the closest store I can buy VS721 BOTTOM COAT? I'll drive all the way to Toronto if I have to"

Tom Wells, Detroit, MI